What is the load output used for on certain Victron MPPT charge controllers
What is the load output used for on certain Victron MPPT charge controllers
Posted by Peter Kennedy on 4/4/2018 to Solar
A typical use for the load output is for a well pump. The well pump will run from the battery as long as the battery is charged. After the sun goes down and the battery starts to run down the load output will turn off and the well pump will stop.
Related Articles
Can I exceed the power rating of my MPPT charge controller?
Here is the table of recommended maximum power ratings: The charge controller will only pass its rated amps which is the second part of the model number. 100/20 means 100 volts maximum input, 20 Amps maximum output. If you have more power ...Suite of Victron parts for Lithium batteries on a boat
The full suite of Victron parts would include the following: Batteries VE Bus BMS - the battery management system BMV 712 battery monitor MultiPlus inverter charger Remote for MultiPlus The Color Control GX (CCGX) is optional, it doesnt do anything, ...Troubleshooting Victron Connect Bluetooth
Here are some troubleshooting tips if you are having difficulty connecting to your solar charge controller. 1. The controller must be powered up and connected to a battery. There should be some indication of life such as a flashing light 2. The ...MPPT troubleshooting section in the instruction manual
The links below go directly to the troubleshooting section of the relevant instruction manual: Smart Solar MPPT 75/10 up to 100/20 Smart Solar 100/30 and 100/50 Smart Solar 150/35 and 150/45 Smart Solar 150/60 and up Smart Solar 150/70 VE Can and up ...New Victron Smart Lithium Battery
The latest Victron battery in the store is the following: BAT512120610 LiFePO4 Battery 12,8V/200Ah Smart These are about half the weight of the current model and clock in at 20.5 kg versus the 43 kg of the previous model. Here they are on the spec ...