Programming
Using a BMV 712 alarm as a signal to start a generator
The Victron BMV series Amp Hour Meters have a programmable relay output on the back of the meter. You can program it to operate based on voltage, state of charge, temperature, or other parameters. The procedure is detailed in the instruction ...
Resetting your BMV battery monitor when you get new batteries
The instructions for the Victron BMV battery monitor are here. The BMV learns the history of your batteries over time. When you replace the batteries you need to erase the history and start again. Here is what it stores: Here is the relevant part ...
Programming the Buck Boost DC DC Converter - Part 2
The Victron buck boost DC DC converter is programmable so you get to decide what inputs turns it on and how long it runs for. The purple and green wire are two connections that you can use, it also has a vibration sensor. You can run the program in ...
Programming multiple MultiPlus inverter chargers
Here is the Victron article on the subject: https://www.victronenergy.com/live/ve.bus:manual_parallel_and_three_phase_systems All the units need to be identical and have the same (up to date) Firmware They want you to have symmetrical wiring for ...
Programming a Buck Boost - Part 1
I went to download the software Unzipped it Had to jump through a few hoops to install it Then it told me I already had it installed. A few minutes later I got this far It wants me to download the USB Driver. What Version of Windows are you using? ...